One piece of the moulding on the drivers side is starting to peel off, what can be used to re-attach the piece? 2 sided tape? Glue?

Thanks.

 

Anyone? Comeon guys!

 

Double sided tape would be the easiest, but don't use that cheap white tape. Go to the automotive section at wallmart (where all the body fillers and fiberglass is), and there should be some grey double sided tape, I think 3M makes it. I used that to reattach my side molding after I painted my door and it worked great.

 

I had that small 2 inch piece (on the front fender) do the same thing on my last car. Actually I broke the snap trying to take it off to paint . But anyway's....I used some silicon glue and just loaded the inside of it. Then I taped it up there for a few hours till it set.