installing tail lights
wned: :lmfao:
Lexus Tech y0!!
Joined: Jan 2004
Posts: 8,321
Likes: 1
From: CT
They're held on by 4 10mm nuts each. Just put the lamp where it's supposed to go and screw on the 4 10mm nuts each. Then pop the bulbs in and your done, you may have to do this before you screw the lamps in.
Last edited by JoePoonani; Jan 19, 2008 at 02:19 PM.
v-card member alpha
Joined: Oct 2006
Posts: 4,010
Likes: 0
From: Assplosion, NE
If it's the same as the 5th gens, which it must be, you just pop off the inner cover in the trunk to expose the nuts JoePoonani mentioned as well as the bulb sockets. Goes faster if you have ratchet or a driver w/ sockets, the driver being my choice as I was a little afraid I might be a bit over zealous and get them too tight, possibly cracking something.
Senior Member
Joined: Oct 2007
Posts: 275
Likes: 0
From: Lehigh Acres, FL
