You grinded the welds on an exhaust pipe. Geez.

 

don't even start!

coz i'll take it off & polish it next! h:

 

How the fuck does that clear the radiator? I had to use pie cuts to get a sharp enough angle to clear the shroud.

 

lol, i'll snap a pic of it all assembled tomarrow.. i drove the car with it tonight & it runs sooo much better!

 

very nice

 

That looks alot better than the last one. Did you get a FAL fan yet, or are u still running the melted stock fan? Are u gonna to powder coat the pipe or keep it as is? Is that mild steel or SS?

 

Thanks a lot man!

to answer your questions, i've got a slim fan from our local parts store, it's on the oppisite side of the radiator & i reversed the polarity so that it's not a push fan. The pipe is 3inch Stainless. I meant to snap a pic of it all installed & post it up, but i've been really busy with everything, i'll try & get that posted up in here tonight after work.

 

should have gone 4 inch...h:

get some pics up biotch....aaaaaaand when you get a chance I need to holla at you about that motor :wiggle:

 

Heres the fresh pix..

Frrom the backside

Under the car

From the top.. (this one is kinda dark)

 

I wish I had all that room for mine.