I am running a fully sleeved motor b16a with darton sleeves a str racing intake and fuel rail with 750cc rc injectors with low compression 8.5:1 turbo pistons a toda racing t belt and oil pump moroso oil pan magnacore 10mm wires msd 6al digital box cap and blaster ss coil, a slightly ported head with oversized valves adj cam gears crower ti retainers and valve springs not sure which set tho with a gt42 turbo and should be seeing around 25-30psi i was wondering if it would be worth the money to invest in a set of cams or just run the stock si ones i am looking to make around 500-700 horsepower and any ideas on what clutch setup to run i will be using the car on the street once and a while and prob drive it to shows

 

thats an awful lot invested into a turbo project to not be able to answer those 2 very simple questions for your self. A set of cams is a good idea in a build as exstensive as yours, and can help you get to the numbers your looking at at. To hold that kind of power your gonna need atleast a 4 puck, but you might end up needing a twin disk set up.

 

This will probably help you out, www.homemadeturbo.com ,good luck.

 

Goddamn 500hp ur lookin at a lot of tickets

 

oke...... :S