Knock in engine, have suggestions on what to do!!
#1
Like to drift!!!
Thread Starter
Join Date: Jun 2006
Location: Highland, NY
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Knock in engine, have suggestions on what to do!!
I have a civic ex96 with a SOHC Vtec engine, the D16YZ8. I have a knock that is really bothering me, maybe someone can suggest some things it might be. The knock is steady when the car is turned on, but when I start to drive, or increase the rpm, the knock starts to increase. The oil is at its required level. I am hopeing its not a piston, and I kind of think its a valve. If anyone can give me advice on what it could be I would gladly appreciate it. Thank you!!
#2
Senior Member
Join Date: Dec 2005
Location: Racine, Wisconsin
Posts: 577
Likes: 0
Received 0 Likes
on
0 Posts
bearings? take off your oil pan....grab each piston rod...and wiggle. if there is any play then you found your problem. also take off the rod caps and look at the bearings. refer to a manual for service.
#4
Like to drift!!!
Thread Starter
Join Date: Jun 2006
Location: Highland, NY
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Have a Haynes book, i'll check it and seen whats up! Thanks!! Oh go check out that F&F TK drift. It was crazy. Get back at ya when pan and rods checked.