hey thanks a lot for your help! do you know what would be involved to do a highbeam? so, what i'll do is cut off my H4 socket, obtain 2 9006 sockets, re-wire them back on, obtain some 9005 silverstars cut-off the tabs and put them in the sockets. that sounds easy enough. i just might have some difficulty w/ the high beam setup. Does anyone know if there is enough space to fit a 9006/9005 bulb in a projector? thanks

 

I have no idea what is going on here. I had no idea you could transform an h4 socket to 9005!

 

Really? Interesting... I think the output is horrible. Planning to retrofit real projectors from German engineering

 

thats my opinion, im not looking for a bmw beam, but the halo projectors are a much more concentrated beam patter, the downside is that it uses a puny h3 bulb. In any case i like them.

 

Just curious though, what headlight housing brand did you get? All the ones I've bought have poor light output

 

lemme check....ah you know what i dont know who makes them, i bought them from autodynamic.com. You have the same ones. How do they look with the hid's? Clean?

 

My first set of projectors were from Autodynamics, the brand WAS Denji, yes they were better than the other 2 sets I've bought else where.. I don't know if you have the same as mine, but even with HID, the light is not as good as a higher quality housing... thus I'm chucking these cheap ones for a better set.

 

who makes a better set?

 

Real BMW or Audi projectors

 

aye, Lots of work there, ill stick with the look-a-likes