Hello everyone. I have a dilemma here I purchased a 91 DA integra that has a swapped in b18b1 motor that also has had a GSR cable transmission in it unknown year within 1000-2000 miles transmission started whining again. So I purchased a JDM b16 transmission that was already in good shape according to a shop, but I had it refreshed just because it was out of the motor and unsealed anyway. recently this b16 jdm trans started whining just like the GSR trans my car vibrates on acceleration on full throttle not sure if its motor mounts (polys), but I did notice something when I installed my new transmission I had axle play. I used the original 91 integra axles that came with the car abs ring is on outside instead of inside towards transmission so I never had to hit it off. My question is do I have the right axles could that be my culprit on why I'm getting transmission whine ? inboard spline is 27 outboard is 26. I know its a JDM b16 transmission from a Honda CRX SI so should I be using the 25 inboard spline axle instead ?