what could have caused it to crack? not a roll pin sticking out? hehe.

 

We're still not able to disconnect the hell housing

 

Alright guys, both trannys are out, and both bell housings are loose, but I cannot get them to come off completely. I need to know what is up so that we can get this thing back on...

Tranny came back out in about 45 minutes, if I can get the bell housings done, I can have it in by 9 or so.... so please help.

 

you wouldnt believe it but u gotta be crude with them, need a deadblow. hehe.

 

 

I heard theres a plug that we take out and stuff from the back so here are some back shots :chuckles:

 

bump

 

bump

 

I can't believe no one in here has an answer for this....


What happened to all my tech guys??

 

ok, I was just looking at this, tell me what you think.

On the auto tranny, is there not a 32mm bolt, but there is probably still a snap ring on the countershaft bearing. so if we took the back case of, there should be the snap ring on the countershaft bearing, take it off, and viola.....

Any opinions??