i have a 94 cx, and it doesn't come from factory with an RPM monitor....i was going to go to the junkyard and pick up an ex/si bezel with one on it...my question is, will i have to run wires or anything to make the RPM monitor work? i was reading on some site a while ago (i don't remember what site) that supposedly the wires are already there for the RPM monitor, all you have to do is just plug the old harness into the new gauge bezel?

can anyone help me out? i did a search and couldn't find what i was looking for....thanks guys.

 

you just have to plug it into your wiring harness, the rpm monitor (tachometer) will work fine off of the ex/si bezel (gauge cluster)

 

:werd: you just swap in the new cluster, plug and play! no wires to run or any rewiring.

 

sweeeett....i was hoping what i read was true...thanks alot guys!!!