Do you want to borrow my unused MAP sensor man?

 

I pulled one off of my old cx motor I am retarded it was at the shop the whole time. does it really sound like my map is bad? I mean it's the only thing I can think of that would do this and I am throwing code 3.

 

Well... can't hurt to try to swap it if you are throwing that code and you have another one available. h:

 

Grab up a 3bar from a BMW M3..

 

so the map sensor didn't fix it but it helped some, hopefully on Friday when I get my new blue box it will help god I hope so.

 

is your code on all the time or just when it gets to a certain RPM?

when i had my greddy kit on my d16, whenever i would get to a certain RPM or full spool, it would throw a CEL and wouldnt go off until i turned off my car. Got a missing link, and re-did the wiring on the blue box (which should be dumped for the e-manage or something a little better), and everything was alright. Although for some reason when i first the kit on, i was boosting 7psi. h:

 

What makes that any better than another 3BAR? :dunno:

 

What do you have for management? Do you have an FMU check valves? missing link?

 

I have the greddy blue box, it is supposed to up the fuel and interrupt the map sensor signal.

It goes on a little after I start my car like it will start fine and then the CEL will come on and I will have a rolling idle then it will Idle at around 11 - 1200 rpm.

 

So anyway I bought a new Blue Box and rewired it, and it is still doing the exact same thing. Can any of yall think of any other ideas? Maybe Sleepers diagram on his website is wrong for wiring the Blue Box I don't know up for any idea's. Wife says fix it or sell it so hurry.