i've been loking at new exhaust for my civic, its a VX with a b18b. i have found that some exhaust systems "will not fit" even though they are made for the si's i was just wondering if this problem can be solved with a custom streight pipe?

 

You could always get a muffler shop to make you all the piping and then just weld a muffler on to the end of it. It's sometimes hard to find full systems prefabed for swaps

 

i hate the sound of custom exhaust systems and i want somthing madral bent, i can get the headers to connect to a prefabbed system i just want to be able to use the stock hangers

 

headers...is that the new b18b v6 model?

 

:chuckles:

 

ha, would you prefer it be called the exhaust manifold. ok yea HEADER quit bein an ass and help spread some knowlage.

 

I will quit bein an ass when you dont sound like one:thumbup: ... every nood gets the headers diss...it is just a part of HAN life...so get used to it and dont take stuff so seriously

 

I modified an integra exhaust to fit my vx hatch. I had to make an extention to make the header collector reach the exhaust, but was still able to use all the stock hanger locations. Whatever exhaust youre considering, I sure the hanger locations match from the back forward (starting at the muffler hangers, then the axle-area hanger, then the two middle hangers--if that makes sense). If you're just having trouble matching the header collector or cat to the exhaust, just have a little pipe fabbed. You shouldn't have any hanger problems :thumbup:

 

I had an extension made. Cost $25.
The drive to the muffler shop with an open header $PRICELESS$