I was wondering how do i install the keyless entry on to a Clifford RS2 alarm system. i did a search and really only found things on the 6th gen

 

ttt

 

i think what you need to do is find the schematic for your alarm. that way you'll know what wires go where. and how to reprogram your alarm. then you'll need actuators for every door you have. you hook those up to your locks and alarm, then you should be set. the actuators run about $75 cdn.
btw. most alarms/keyless entries work for any year/model/trim car. so the 6th gen info would basically be the same for any car. i mean how different can locks be on different cars??

 

i got the actuators, they have two wires my guess is on posi and one neg. i just need to know how to hook them up.

 

there is a relay by the backup battery in the car. you have to just wire up the wire to that relay. the relay is already connected to the alarm brain. once the car is running take it to a best buy or cc and they cant tell you to connect what wires to what.

 

post what u have done and ill walk u thru it, i done bout 3 of these, so simple. i done two viper 790xv and a clifford 3.5rs all remote start and all.

 

ok thanks i will get pics once i get the car.