PSPEC,
This was four years ago and since then the forum has switched softwares. They used to use vBulletian which is just like this and that's when I frequented the site but when they switched to that new software I just stoped going. I never liked it and they lost there archieve.

You could always start a new post.

About the ITR rotors. You are right that in most cases the outside and inside edge of the rotor don't wear because the pad's surface does not make contact there but when they are resurfaced they are completely leveled. Maybe yours have been resurfaced.

What is the minimum thickness for those rotors? It should be stamped on them.