I recieved and installed my new 1 piece(non projector) headlights just yesterday. I had done the fog light trick for them to run with out the headlights prior to this, and it worked fine. Now that I install the new housings, and connect wire to wire for the fog lights, they ran for about 15 minutes, and then would blow the 15A fuse for Instrument Panel, Park, Fog, and Tail lights. I replaced the fuse(15A), and did it again. same out come, So I replaced the fuse and tried a different approach and wired the fogs to the parking lights, which also worked for about 10 minutes and blew the same fuse AGAIN.. Now, is my only remedy for this running a separate relay to some sort of switch ?..

Some one had mentioned using a bigger fuse, such as 30A in place of the 15, But I will not risk this unless i am 100% sure I wont either starta fire, or actually blow my fog bulbs... I do not want to risk ruining the housing..