Theres a few ways to do it.

You can wire the voicecoils together to get a 2 OHM load and wire it to the amp without bridging it. But you will be only getting 280 watts and not using all of the amp.

You can wire the voicecoils to get a 2 OHM load and bridge it to the amp. Then see if that will bring it into protection mode. Obviously, if it does, then this set up wouldnt work. This is risky though.

You can also attempt to not wire the voicecoils together, but wire each one directly to the amp and give each voicecoil 220 watts. Just be very careful about setting the gain and crossover the same. Kinda risky and ghetto also.

h: