Originally Posted by
t3t4delsol
the iacv is located on the back of your intake mainfold, there are three bolts that hold it in and it has two lines that run too it, remove the 3 bolts and the lines pull it off, sit it on the ground and begin to spray seafoam or carbcleaner inside the opening, let it sit in there and soak for a good 20 mins, there is a small screen at the one opening make sure you spay the crap out of that to get all the holes on the screen open, after letting it soak in for 20 mins turn it over dump it out and repeat the process for another 5 mins, turn it over again let it sit like that for an hour so the inside drys out,then reinstall
Ok I did what you said, however the iacv on d16y8 isn't at the back of the manifold it's under the throttle body. Unless i cleaned the wrong thing. I had to unbolt the whole throttle body, take off the two hoses, so I could flip it over to get access to IACV which was bolted on by four small bolts. I just wanted to clarify for anyone else who tries on the same engine. Anyway, it didn't work.