Originally Posted by
SUPER LAUBO
:lmao: that's a freaking awesome drawing.. but i concur with mr. boogers.
you can potentially burn up your amp. you have to find out the resistance of those subs. if they are 4 ohm, your amp will be seeing 1ohm, which will most likely overheat.
when you parallel your subs (the method boogers told you) the resistance is cut in half. when you bridge your amp the amp will see half the resistance, hence 1 ohm for 4 ohm subs.
for that setup to work without the potential for your amp to burn up, you need 8 ohm subs or have one sub for each channel.
where did you get 1ohm from?
Originally Posted by
b00gers
Are you sure when you bridge the amp, the impedance is cut AGAIN?
Given that diagram and those subs being 8ohm SVC....the amp would be seeing a 4ohm load.
If those subs in the diagram were 4ohm, then the amp would be seeing a 2ohm.
Correct me if I am wrong.
that's correct
