Someone on this site had a nice How-To (even had a video!) for separating the lower control arm from the lower ball joint. I need to actually replace the lower ball joint because of a botched half-shaft replacement (don't ask). As most of you know, the ball joint is pressed in.

The ball joints are rather inexpensive, but it is the actual job that I'm worried about.

What is the easiest way for a do it yourselfer to replace the lower ball joint?

Does anyone have a nice how-to like the one mentioned above explaining what to do?

I usually find that while I have a nice selection of tools, I am ALWAYS missing the "right tool for the job" (hence the reason I'm in this mess as it is, hehe).

All comments/information greatly appreciated.

-bin