Originally Posted by ej8_hamazaki
I tapped the Starter output to the Starter wire after the switch (usually red) located at way up corner under dash attach to a 1 inch white connector. I pulled the connector with a loop wire (one piece) so its easy for me to solder the wires.
I installed it on my 99 Civic. What is yours?
If ever u hook it up and made it work, make sure to put ur car in neutral prior leaving the car to avoid accident since ur system is not designed for manual tranny.
12Volts
I am not worried about leaving it in Neutral because I have a turbo timer, so the car is in neutral when I shut and lock the doors anyway because it is still running.
I think I may have found my error: I only hooked up one starter wire. After looking at the instructions a little further, I have determined that I need to have one wire (purple) hooked up pre-ignition switch and the other wire (green) hooked up post ignition switch. Is that how it usually works?
When I get a free moment, I may try and get it working again, but I am in no hurry since I don't really need the remote start and plus, I will have to solder the clutch switch wires together. They are way the hell up there and I am really not looking forward to that.