View Single Post
Old Sep 15, 2005 | 04:17 PM
  #13  
Jim Fiaschetti's Avatar
Jim Fiaschetti
Registered User
 
Joined: Sep 2005
Posts: 17
Likes: 0
Default My MES connector WILL NOT come out of the fuse

panel.... perhaps I am going after the wrong connector, I have read that it should be a two wire connector that goes to nothing.. I have seen that one stuck to the body under the dash.... but damn, I cannot get the yellow two wire connector off of the fuse panel, I hope I am going after the wrong one... I have replaced the driver's airbag, switched the connector from the '96 bag to the '94 bag and need to reset the light.... please advise if the connectore I need to short is the one with the dead end on it... that would be a simpler task for me to accomplish.

The supposed MES connector on the fuse panel is in a nasty place and the release is on the back side... I have tried everything to get the connector out, and I basically give, will get someone to reset it with a handheld if no solution appears here.... thanks in advance....

Again on another site I read that the MES may be a two wire harness hanging connected to nothing....

http://www.acuraworld.com/tsb/2002/B02-015.pdf
Reply