Ok everyone, tell you a little about my car before i tell about all this.
I've got a 92 hatch with a jdm H22a in it. I have Skunk2 cams, gears, i/h/e/ flywheel, dss axles, and alot of other stuff, but to the point.
Before i took my car in to get my cams put in it ran great with no problems. After i got my cams put in my timing belt rubed on the inside of my valvecover and broke and didnt bend any valves.
So i had the side cut off, timing belt changed, and the tensioner changed, and the belt still rides out to the outside of the camgears far enough that it hits the balance shaft pulley off the crank. WTF if makes the GRRRRrr noise that everone hears and my brand new tensioner even went bad.
Ok, now i had the tensioner replaced again, and not the whole car vibrates when the motor is on, and its still rubbing on the pulley.

WTF should i do? ive been going through this sheet for months now. I just want it to be over with. Any help would be great.