FS:Testing: 1991 Crx Si Project
Thread Starter
Zc powered ED9
Joined: Jun 2004
Posts: 900
Likes: 0
From: The 607: Ithaca, NY
FS:1991 Crx Si Project
Here are the specs - 1991 Honda Crx Si
-134k on chassis
-JDM b16a1 Motor (50-60k on it)
-LS Transmission w/y1 gears
-ACT 6 Puck Clutch w/extreme pressure plate
-ACT 12.5 light flywheel,chromolly
-Driveshaft stage 2 axles
-Hasport Shift linkage w/short shifter
-Hasport Motor mounts
-New Placing Racing Crossmember w/4th motor mount
-JE 9:1 Compression
-Eagle Rods
-Knifedged Crank
-Type R Oil Pump
-Type R Water Pump
-Type R Valves,Valve Springs,Reatainers and Cams
-Brembo Stainless Steel brake lines (Fronts installed,rear ones not)
-MSD 6al Box
-MSD Blaster 2 Coil
-High Flow Cat
-2 1/2" Exhaust w/4 1/2" Muffler
-Neuspeed Race Springs
-KYB 4way (3way?) Adjustable Struts
-Neuspeed Front Upper Strut bar
-Neuspeed Lower tie bar
Story:
The car was a former turbo project car.The turbo equipment was only 3/4 there when i got the car, so I sold the parts and took it back to N/A.
The car will turn over and it does run,but it needs to be completed.Great project but needs some time to be completed,which i do not have.Needs an O ring in the oil pump,but i am having that done.Other than that,it is justa matter of re-mounting the bumper support, bumper, installing the lights/turn sigs,(all of which i have)and it's rolling.Interior is in good shape as well,and the body is in good shape too.
Lots of goodies with this car,so am asking $4000.00 OBO.
Contact me via Pm,phone or email.
Cory @ 607-533-4877
Pics:
-134k on chassis
-JDM b16a1 Motor (50-60k on it)
-LS Transmission w/y1 gears
-ACT 6 Puck Clutch w/extreme pressure plate
-ACT 12.5 light flywheel,chromolly
-Driveshaft stage 2 axles
-Hasport Shift linkage w/short shifter
-Hasport Motor mounts
-New Placing Racing Crossmember w/4th motor mount
-JE 9:1 Compression
-Eagle Rods
-Knifedged Crank
-Type R Oil Pump
-Type R Water Pump
-Type R Valves,Valve Springs,Reatainers and Cams
-Brembo Stainless Steel brake lines (Fronts installed,rear ones not)
-MSD 6al Box
-MSD Blaster 2 Coil
-High Flow Cat
-2 1/2" Exhaust w/4 1/2" Muffler
-Neuspeed Race Springs
-KYB 4way (3way?) Adjustable Struts
-Neuspeed Front Upper Strut bar
-Neuspeed Lower tie bar
Story:
The car was a former turbo project car.The turbo equipment was only 3/4 there when i got the car, so I sold the parts and took it back to N/A.
The car will turn over and it does run,but it needs to be completed.Great project but needs some time to be completed,which i do not have.Needs an O ring in the oil pump,but i am having that done.Other than that,it is justa matter of re-mounting the bumper support, bumper, installing the lights/turn sigs,(all of which i have)and it's rolling.Interior is in good shape as well,and the body is in good shape too.
Lots of goodies with this car,so am asking $4000.00 OBO.
Contact me via Pm,phone or email.
Cory @ 607-533-4877
Pics:
Administrator ☂
Joined: Jul 2002
Posts: 56,734
Likes: 3
From: NY
** New Rule: Please Note the State of Where Vehicle is Being Sold in the TITLE
Effective 11/29/04
Please, as courtesy to potential buyers, note the state or providence of where the vehicle is located in the SUBJECT of the thread.
Example:
FS: 1998 Acura Integra; SoCal
This will greatly help both parties.
Please be sure to specify the state in the thread title.
All threads that don't follow this rule will be CLOSED.
Thank you all for your co-operation.
Effective 11/29/04
Please, as courtesy to potential buyers, note the state or providence of where the vehicle is located in the SUBJECT of the thread.
Example:
FS: 1998 Acura Integra; SoCal
This will greatly help both parties.
Please be sure to specify the state in the thread title.
All threads that don't follow this rule will be CLOSED.
Thank you all for your co-operation.
__________________
9Y0 Cayenne GTS
E46 ///M3
YD4 MDX - SOLD
EG Ferio - SOLD
FA Ferio - Returned
www.NelsonLee.net
9Y0 Cayenne GTS
E46 ///M3
YD4 MDX - SOLD
EG Ferio - SOLD
FA Ferio - Returned
www.NelsonLee.net