Im starting to build up a decent stock of tools for my garage. One that I've been wanting for a while is a good tap & die set to clean up bolts and threads. My question is does anyone know what the typical threads that honda uses are? I know most everyhting is M6, M8, M10 or M12 but I'm not sure on the pitches, honda seems to use two different pitches, depending on the application. Some of them seem to have a smaller pitch than what is commonly considered "fine". So if anyone has any kinda list, post it up.

 

Been lucky with not cross threading. I can't tell you what the pitch are for common Honda bolts

 

anyone know what size the rear lca bolts on an ek are?

the ones that connect to the strut.

 

yeah not from from cross threading just rust and shit. up here if it in the bottom 2ft of the car, it is rusty.

 

Try 14mm