Small photoshoot or my EG8 sedan. All Go!
#1
Fuckin eh
Thread Starter
Join Date: Jan 2005
Location: Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Small photoshoot or my EG8 sedan. All Go!
Old car destroyed itself lol.. Hood blew open crushed hood, window, roof, wipers, sunroof, pillar.
RIP
I introduce you to my new friend Casper & Everything its swaped over from the old car
Championship White here I come
RIP
I introduce you to my new friend Casper & Everything its swaped over from the old car
Championship White here I come
#3
Fuckin eh
Thread Starter
Join Date: Jan 2005
Location: Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
#9
Fuckin eh
Thread Starter
Join Date: Jan 2005
Location: Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Engine:
B18C1 GSR
Port & polish head
5 angle valve job
Rage block gaurd
JE 8.8:1cr pistons w/ JE Pro seal rings
Eagle H-Beam connecting rods
ACL bearings
BBK SSI Intake manifold
BBK 70mm throttle body
3in turbo back, all straight pipe.
T3/T04e .63/.50 a/r with .57T compressor wheel
Equal lenth tubular Ramhorn manifold
Greddy TypeS BOV
Mishimoto 32x12x3 FMIC
880cc injectors
walbro 255lph pump
38MM Turbosmart External wastegate w/7PSI spring
Greddy Profec B spec II boost controller
8.5mm MSD wires
Crane Hi-6R TRC-2 boost timing retard control
Crome tuned P72 ECU
Drivetrain:
01 GSR Y80/ OBX LSD
Suspension:
Skunk2 draglaunch 1008lb coilover setup
Maxspeed front & rear strut tower bars
lower tie bars front & rear
Rear C-pillar bar
Rough mod list I made a long time ago, give ya an idea of what she has going for her. THeres been quite a few setup changes & much done. but its a long list, so some other time lol.
B18C1 GSR
Port & polish head
5 angle valve job
Rage block gaurd
JE 8.8:1cr pistons w/ JE Pro seal rings
Eagle H-Beam connecting rods
ACL bearings
BBK SSI Intake manifold
BBK 70mm throttle body
3in turbo back, all straight pipe.
T3/T04e .63/.50 a/r with .57T compressor wheel
Equal lenth tubular Ramhorn manifold
Greddy TypeS BOV
Mishimoto 32x12x3 FMIC
880cc injectors
walbro 255lph pump
38MM Turbosmart External wastegate w/7PSI spring
Greddy Profec B spec II boost controller
8.5mm MSD wires
Crane Hi-6R TRC-2 boost timing retard control
Crome tuned P72 ECU
Drivetrain:
01 GSR Y80/ OBX LSD
Suspension:
Skunk2 draglaunch 1008lb coilover setup
Maxspeed front & rear strut tower bars
lower tie bars front & rear
Rear C-pillar bar
Rough mod list I made a long time ago, give ya an idea of what she has going for her. THeres been quite a few setup changes & much done. but its a long list, so some other time lol.