Ace Body Kit from VIS
Thread Starter
DO IT RIGHT THE 1st TIME
Joined: Aug 2002
Posts: 112
Likes: 0
From: LB
Ace Body Kit from VIS
Hey everyone,
I just installed the ACE body kit from VIS for my 95 GSR (JDM) and was wondering if anyone out there has seen any bodywork done to the side-skirts. To be specific, the sideskirts have three screws onto the oem sides and when you open the door it kinda looks ghetto because you can see that the side-skirt doesn't go all the way to the body of the car. You can definitely see that there's a skide skirt over the OEM because it only reaches to about half the OEM towards the body. I've seen a couple of ITR with the same sides but have never taken notice on how they look when the doors are open. So I was wondering if anyone has seen them molded on the the OEM side-skirts or left as is. I really don't want to mold it onto the OEM sides because the only way to take it out would be to damage the bodywork but then again it would be clean and permanent. Furthermore, I would have to definitely worry about cracking because of openning and closing the doors! I'm not too worried about leaving them as is because it's only an eye-sore when the doors are open and plus if i ever need to remove them it'll be easy. I just wanna hear any suggestions or opinions on how to approach the bodywork for my side-skirts!
I just installed the ACE body kit from VIS for my 95 GSR (JDM) and was wondering if anyone out there has seen any bodywork done to the side-skirts. To be specific, the sideskirts have three screws onto the oem sides and when you open the door it kinda looks ghetto because you can see that the side-skirt doesn't go all the way to the body of the car. You can definitely see that there's a skide skirt over the OEM because it only reaches to about half the OEM towards the body. I've seen a couple of ITR with the same sides but have never taken notice on how they look when the doors are open. So I was wondering if anyone has seen them molded on the the OEM side-skirts or left as is. I really don't want to mold it onto the OEM sides because the only way to take it out would be to damage the bodywork but then again it would be clean and permanent. Furthermore, I would have to definitely worry about cracking because of openning and closing the doors! I'm not too worried about leaving them as is because it's only an eye-sore when the doors are open and plus if i ever need to remove them it'll be easy. I just wanna hear any suggestions or opinions on how to approach the bodywork for my side-skirts!
Thread
Thread Starter
Forum
Replies
Last Post
skyliner186
Parts Classifieds
7
Nov 20, 2005 07:47 AM
defconsieffect
Parts Classifieds
0
Aug 24, 2003 03:21 PM