I know that this isnt the place to post anything that could be considered slightly rice, but i just need some opinions as far as craftsmanship is concerned. I am in the process of putting a kit on my car, but the kit i ordered sucks. so rather than throwing a piece of shit on my car, i am working as hard as i can to make it the best it can be. I am fiberglassing and bondoing the kit directly to my car. which means no gaps, no lines, nothing. Its a lot of work, but i think im getting it pretty well. I just want some opinions from outside sources who have seen worse, and better, but can give me a hint as to how i am doing. and for those who are going to criticize, i know altezzas are played out, my wing is way too big, and the decals are stupid. so now thats out open, let me know what you think of the installation so far on my rear bumper. thanks!

 

craftmanship only! its not bad at all man. i just hope the bumper is properly secured and its not just bondo filling in those gaps. bondo will crack.. so use as little bondo as u can. did u use any fasteners and fiberglass before u bondo'd it?

cough tezza's, kit, wing, decals rims gross cough cough

 

used fasteners and fiberglass before laying down the bondo. I know, i know... but this is what i like to see... and the wheels, its winter so you cant hold that against me, the weather's pretty rough in ohio... but honestly, i did it right when i started and used all the right stuff to make it strong...

 

you mean to tell me you like your hondas to look like that? u did a good work on the bumper props to you, with that spoiler I could maybe squeeze my body therw that opening :lmao:

 

looks good.. from what i can see. You need new pics w/o the sun, since you cant see much.

 

good to hear. i'd say you did a very good job on the bumper then. it hsould hold pretty well.

if u take of the wing i think it'll help clean up the car alot. its just so huge and flashy that it really puts a :thumbsdown: on the car as a whole.

good luck with it

 

wtf...since when did all the HANers be ricers? And wtf is "craftmanship" ? Im not against your bodywork...but rip that stupid wing off, and u should thro those teezers in your trash soon...

no blamin..

 

Not bad. I'm not sure about the fins underneath but overall, I say not bad at all.

 

holy wing, but the molding on the bumper looks decent

 

from what its visible looks very well done... maybe pics w/o so much glare