Notices

Any internal mods required for superchargin the S2K

Thread Tools
 
Old Sep 24, 2005 | 02:15 AM
  #1  
skunkdc2's Avatar
skunkdc2
Thread Starter
SKUNKDC2
 
Joined: Sep 2005
Posts: 14
Likes: 0
From: Canyon Country
Default Any internal mods required for superchargin the S2K

thinkin bout getting a s2000. and for the s2k im going to get the vortech charger...i like to push all my cars to the edge..but if i was to run her on a 12psi high boost pulley, would it require internal mods?
Reply
Old Sep 27, 2005 | 08:02 PM
  #2  
h22accord's Avatar
h22accord
155mph and still climbing
 
Joined: Sep 2004
Posts: 219
Likes: 0
Default

be prepared to spend BIG $$$$. As i am starting to find out EVERYTHING for the s2k is expensive. Im sure if you had a REALLY good tuner you MIGHT be able to squeeze 12psi out of it. But i seriously doubt that it would last very long. more than likely you will have to build the bottom end to boost that much or more.
Reply
Old Oct 1, 2005 | 08:46 PM
  #3  
dubcac's Avatar
dubcac
I
 
Joined: Jan 2001
Posts: 56,525
Likes: 0
From: Westside til I die
Default

I probably wouldn't run a stock blocked s2k to 12psi...it COULD be done with the right setup, fuel management, and engine management...and an awesome tuner. But, who knows how long it would last...and there's a small margin of error there.
__________________
2015 Ford Mustang GT Fastback - Ingot Silver - 6M - Performance Package - Gibson Catback, JLT CAI, FR 47lb injectors, BAMA E85 tune, Eibach Sportline, BMR wheel hop kit, UPR oil separator, Steeda shifter bushing/bracket
Team B.O.B.® - Ballaz on a Budget
Reply
Old Oct 10, 2005 | 07:19 AM
  #4  
AustinS2k2003's Avatar
AustinS2k2003
Registered User
 
Joined: Oct 2005
Posts: 9
Likes: 0
Default

I'd say go TC if you are going to up the PSI on the S2k. SC runs about 5k (Vortech or Comptech). I think the Comptech has betterr power gains over the Vortech too. This topic has been discusssed much on s2ki.
Reply
Old Oct 15, 2005 | 08:50 PM
  #5  
blkturbos2k's Avatar
blkturbos2k
S2K+TURBO=600rwhp
 
Joined: Oct 2005
Posts: 25
Likes: 0
From: sterling va
Default

Originally Posted by skunkdc2
thinkin bout getting a s2000. and for the s2k im going to get the vortech charger...i like to push all my cars to the edge..but if i was to run her on a 12psi high boost pulley, would it require internal mods?
If you run the car on 12psi and the stock C/R the car will blow asap. You would have to run C16 gas all day and its $13 A GALLON
Reply
Old Oct 17, 2005 | 06:00 PM
  #6  
Sideways's Avatar
Sideways
Junior Member
 
Joined: Jan 2004
Posts: 14
Likes: 0
Default

As dubcac says, it COULD be done with the right setup, fuel management, and engine management...and an awesome tuner. But, who knows how long it would last...and there's a small margin of error there.

I have the right setup and currently I'm pushing 13 psi with a Vortech.

As far as AustinS2k2003's post, the Vortech can flow 1000 cfm where the Comptech Novi 1000 only flows 850 cfm.

It is all dependent on the tuner.
Reply
Old Oct 22, 2005 | 04:27 AM
  #7  
blkturbos2k's Avatar
blkturbos2k
S2K+TURBO=600rwhp
 
Joined: Oct 2005
Posts: 25
Likes: 0
From: sterling va
Default

Originally Posted by Sideways
As dubcac says, it COULD be done with the right setup, fuel management, and engine management...and an awesome tuner. But, who knows how long it would last...and there's a small margin of error there.

I have the right setup and currently I'm pushing 13 psi with a Vortech.

As far as AustinS2k2003's post, the Vortech can flow 1000 cfm where the Comptech Novi 1000 only flows 850 cfm.

It is all dependent on the tuner.
Are you running 93 octane
Reply
Old Oct 22, 2005 | 10:20 PM
  #8  
Sideways's Avatar
Sideways
Junior Member
 
Joined: Jan 2004
Posts: 14
Likes: 0
Default

91 octane.
Reply




All times are GMT -8. The time now is 04:55 PM.