I'm planning on doing some modifications to my h22a dohc vtec motor and I was wondering what internals I should buy. I'll be saving up to get the cash for the internals of course.

Anyways this is what I'm thinking about getting:
Crower Rods
JE Pistons 11.5:1 compression
Balancing my Shafts
Web Stainless steal valves, valve springs, and retainers.
Ported Polished and Port Matched
3 angel valve job
Thinking of changing my cam gears to STR Cams

Other mods I'm thinking of doing are the fallowing:
DC 4-2-1 headers
ECU: Chipped P72

DRIVETRAIN:
Clutchmasters Stage 3 clutch
Clutchmasters enlightend flywheel

How much approximately do you think this is going to run me? Yes this car is going to be running on the street so yeah let me know where I can purchase these parts from any online store or just regular store. Post here thanks.

 

do you already have the block sleeved? if not you'll need to figure that in as well, unless you're getting the coated slugs, etc etc etc.

the DC header probably won't do much for you.

otherwise looks like a good setup for the most part, cept i've never heard of an "enlightened" flywheel :beer:

 

No the block hasn't been sleeved yet. I won't be able to start building up the motor for another month or so. How much do you think it'll cost me to sleeve the block? Yeah I realized that about enlightened flywheel my bad, I meant lightened flywheel. How much do you think this will all cost me?

 

the block resleeving is somewhere around 700 - 800 bucks. my guess is around 3000-3500 bucks depending on who's doing the labor.