I have a hard time to get 3 nuts off at the Catalytic Converter from the stock exhaust. I am thinking to go buy the air Ratchet wrench with 60 ft. lbs. of working torque . I just wonder, is the Ratchet wrench have enough torque to lose those nuts? If anybody know please help me out? I am new to this forum. Thank you very much.

vinux

 

I doubt 60 would get it off since they're most likely old and rusted on. Just spray it with some Liquid Wrench, bang it a few times, then let it sit for a few minutes then try it.

 

Yup that's all we did with mine both time. I would try by hand as well I know I can produce WAY more then 60 ft/lb or torque.

 

Thank you for your help... I got it off already. I put the exhaust in too. Very good and deep sound. I like it. I'll post the picture tomorrow. :-)