How to Install.....Buddy Club Earthing Ground Kit???
08-18-2005, 09:49 AM
#1
Senior Member
Thread Starter
Join Date: Dec 2003
Location: AZ
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
How to Install.....Buddy Club Earthing Ground Kit???
It's a voltage regulator.....and 3 grounding wires.
The voltage regulator is simple. Positive and Negative terminals.
BUT: The 3 other ground wires coming from the box. Which is the best place to ground them?
Here's a link to the kit I got.
http://www.inlinefour.com/budclubeargr.html
I belive 1 wire grounds to chassis.....Others to Block, Tranny, Intake Manifold? :P
PS: instructions in Japanese. =(
The voltage regulator is simple. Positive and Negative terminals.
BUT: The 3 other ground wires coming from the box. Which is the best place to ground them?
Here's a link to the kit I got.
http://www.inlinefour.com/budclubeargr.html
I belive 1 wire grounds to chassis.....Others to Block, Tranny, Intake Manifold? :P
PS: instructions in Japanese. =(
08-23-2005, 01:21 AM
#2
Member
Join Date: Jun 2002
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
I got a Buddy Club lightweight battery + Condenser unit .. I slapped the condenser on the back of the battery .. ran one ground to the OE chassis grounding location near the battery (and remove the OEM ground), one ground to the bottom rear throttle body bolt, and one ground around to the valve cover on the drivers side (and removed the OEM ground there too) ..
NOTE: im not 110% sure that removing the OEM grounds is save with this unit .. but I havent really had a problem and everything seems all well so far.
NOTE: im not 110% sure that removing the OEM grounds is save with this unit .. but I havent really had a problem and everything seems all well so far.