auto to manual trans swap
#1
Registered User
Thread Starter
Join Date: Dec 2003
Location: Alabama
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
auto to manual trans swap
i have a 92 prelude S, with the f22a1 motor and auto transmission. im thinkin about the h22 swap with manual trans, would it be a pain in the butt to switch transmissions?????
#3
not if you're already swapping the engine.
you'll need some more parts (like a new ECU) but if you're swapping the H22, it might come with. ask your builder/parts source, but OTOH you'd need a new guage cluster and ecu.
but i think it won't be too tough to swap trannies if your swapping in a h22.
you'll need some more parts (like a new ECU) but if you're swapping the H22, it might come with. ask your builder/parts source, but OTOH you'd need a new guage cluster and ecu.
but i think it won't be too tough to swap trannies if your swapping in a h22.
#6
Senior Member
Join Date: May 2003
Location: Long Island, NY
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by ludeboom
for the actual tranny conversion:
u just need the shift linkage, shifter plate, shifter, clutch pedal and clutch master cylinder assembly
for the actual tranny conversion:
u just need the shift linkage, shifter plate, shifter, clutch pedal and clutch master cylinder assembly
#9
Senior Member
Join Date: May 2003
Location: Long Island, NY
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Pelka
Cool thanks, any suggested places to buy?
Cool thanks, any suggested places to buy?
start lookin on ebay, and around junkyards and searching the net
usually you get the linkage with the swap, the pedal and clutch master cyl is a junkyard item, so is the shifter and middle console plastics
its really not that hard to do, specially if u are doing it while doing the engine swap
once the engine is out of the car, removing and replacing any underhood subsystem is magically a 10 minute job.
~boomer
#10
::..Prelude..::
Join Date: Jul 2003
Location: Worcester, MA
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by ludeboom
that is the tricky part
start lookin on ebay, and around junkyards and searching the net
usually you get the linkage with the swap, the pedal and clutch master cyl is a junkyard item, so is the shifter and middle console plastics
its really not that hard to do, specially if u are doing it while doing the engine swap
once the engine is out of the car, removing and replacing any underhood subsystem is magically a 10 minute job.
~boomer
that is the tricky part
start lookin on ebay, and around junkyards and searching the net
usually you get the linkage with the swap, the pedal and clutch master cyl is a junkyard item, so is the shifter and middle console plastics
its really not that hard to do, specially if u are doing it while doing the engine swap
once the engine is out of the car, removing and replacing any underhood subsystem is magically a 10 minute job.
~boomer