I had just purchased a JDM genuine Honda strut bar for my 2001 and when i went to install it i had a problem....most strut bars screw into the bolts that hold the strut...but this has 2 bolts and they screw into 2 holes (that are covered by plastic things). Well wen i actually got the bolts to screw into the hole, i realized that the plate that holds the strut to the body is covering up part of the hole...so tommorow i am going to take both struts out rim out the plate a little bit and put the strut bar in...The question i have is... since the bar is only going to be screwed into the body, not holding the 2 struts together, will it make a difference?? PM or reply...thanks

 

damn all that trouble for a strut bar
should've went with the Neuspeed or skunk2
good luck

 

Got it in...wasnt too hard didnt have to remove strut, just lower it a little..i could feel the difference and i love how it looks stock

 

PICS

i want one now

 

forrreals....PIX PLEASE....!!!!!

 

It's a standard OEM piece, black stamped steel and tubiing. As for bolting it ot the car? I've seen them and they install just like any other tie bar, take the two bolts off that hold the strut in and drop the bar on and bolt it back down.

 

To install it properly u need the strut bar mounts that go onto you suspension

 

werd...