stroker honda dart motor+pistons and crank
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Location: West Chester Pa
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
stroker honda dart motor+pistons and crank
NEW
Standard deck height "B" Series Dart block.
Crower 92mm stroker crank.
Custom CP dish (-14cc) pistons that should yield a little under 9.5:1 compression ratio with a V-Tec head.
Premium CP rings
Crower Super-A beam rods.
King rod and main bearings.
Block was professionally assembled (bored, honed, decked, pressure checked, and oil squirters installed)
Was Orig 5,000
and purchased from RACE ENGINEERING
http://www.raceeng.com/
Moving and needs to go.
Email
Jldahl614@gmail.com
or contact
Jen @
610-873-0686
Standard deck height "B" Series Dart block.
Crower 92mm stroker crank.
Custom CP dish (-14cc) pistons that should yield a little under 9.5:1 compression ratio with a V-Tec head.
Premium CP rings
Crower Super-A beam rods.
King rod and main bearings.
Block was professionally assembled (bored, honed, decked, pressure checked, and oil squirters installed)
Was Orig 5,000
and purchased from RACE ENGINEERING
http://www.raceeng.com/
Moving and needs to go.
Jldahl614@gmail.com
or contact
Jen @
610-873-0686