Complete D16 Engine Assembly- Dynoed at ~150hp on 93 octane. Crane Cam (grind #238/370-25R-10), fully ported head by Autosport South, bored .040 over, new Honda pistons (balanced) and rings, new Honda rods (balanced and polished), balanced crankshaft (Schooler Engineering), lightweight and balanced flywheel, matched custom Autosport South intake manifold, Mikuni 40 PHH Side Draft Carbs with tons of air choke sets, air towers, air jets, fueld jets, pilots jets, pump jets, gasket sets, and shop manual with lots of tuning notes. Great motor...was taken out of 88 CRX Prepared-class autocross car running perfect and stored for the past couple of years. That CRX was headed for ITA so had to install a stock motor. Looking to get about $950 for it. Parted out, it would be worth almost twice that. This engine was built correctly by a long-time Honda racer and mechanic. Located in Jacksonville, FL.