COMPLETE B16A SiR II Swap with LSD, aftermarket stuff!!
11-28-2005, 07:51 PM
#1
Registered User
Thread Starter
Join Date: Oct 2003
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
COMPLETE B16A SiR II Swap with LSD, aftermarket stuff!!
I have for sale a B16A SiR II Swap. It came from Hmotors online and has not been installed in a car yet. Theres no doubt in my mind this motor runs perfectly. We have ordered around 7 or 8 swaps from them and EVERYONE has ran no less than perfect. The only reason I'm selling it is because we just put a single cam in the car that it was going into. It comes with ECU, Shiftlinkage, JDM wiring harness, Mounts, Axles, Head, Intake Manfold, All the sensors, Head, Oil pan, ect. It has a aftermarket clutch type LSD that came with it in the B16A tranny and a Exedy Stage 1 Clutch and Fidanza Lightweight Flywheel which has around 1000 miles on it. We had them laying around the shop, so we just put those in also. Im also going to throw in the Kaaz LSD oil for the install.
If you order this swap from Hmotors your looking at $2550 plus shipping.
Im asking $2000 OBO. (Plus shipping of course)
Any questions just email me. j87w@hotmail.com
Thanks
BTW Heres a quick snap shot of the motor...
http://www.we-todd-did-racing.com/we...ZkMzF5NTQx.jpg
If you order this swap from Hmotors your looking at $2550 plus shipping.
Im asking $2000 OBO. (Plus shipping of course)
Any questions just email me. j87w@hotmail.com
Thanks
BTW Heres a quick snap shot of the motor...
http://www.we-todd-did-racing.com/we...ZkMzF5NTQx.jpg
11-30-2005, 07:13 PM
#8
Registered User
Thread Starter
Join Date: Oct 2003
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
BTW, the only reason it has any "dirt" on it, is because our shop caught fire and we had to spray it out with the extinguisher. So it was far away but now everything has that dust on it.