Gsr rear brake problems.
#1
Junior Member
Thread Starter
Join Date: Jul 2010
Location: Wisconsin
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Gsr rear brake problems.
i got an 99 integra gsr and i changed my rear brake pads like a year ago, but the driver side rear works and the passenger rear doesn't work when i pull the e-brake . when i pull the e-brake it goes all the way up and only the driver side rear brake works. When i brake all four of them work but the passenger side is a little slow.
__________________
__________________
#4
Junior Member
Thread Starter
Join Date: Jul 2010
Location: Wisconsin
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
oh i tried that already.
didn't work. the driver side cable is more tense than the passenger side one.
the passenger side cable pulls all the way up making the bracket look like this "/". if you get the picture.
didn't work. the driver side cable is more tense than the passenger side one.
the passenger side cable pulls all the way up making the bracket look like this "/". if you get the picture.
#5
Member
Join Date: Mar 2010
Location: San Diego, California. .
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Check to make sure your caliper compresses and decompresses, it may be stuck in the open position. . . you may need a new caliper, same think happened to me on my 96 Ls sedan. . .
#7
Moderator
u cant use a c-clamp on the rear, its the turning kind with the X.
maybe you didnt get the brake pad nimple in the groove of the "X"?
maybe you didnt get the brake pad nimple in the groove of the "X"?
__________________
DB Squad
Integra Forum Moderator
2016 BMW 340i M-Sport / 2013 Chevrolet Volt / 1999 Subaru Impreza RS EJ205
DB Squad
Integra Forum Moderator
2016 BMW 340i M-Sport / 2013 Chevrolet Volt / 1999 Subaru Impreza RS EJ205
#9
yes you can use a c clamp in this kind of situation. i forgot you need an ajjustable plier to turn the piston while pressing with the c clamp... works coz inve done it a couple of times at the shop. new trick eyy