I just ordered one this morning
(was -42F and the car wouldn't start)

How do these install? The screw into the block right? Where? What tools required? Easy?

Tips?

Thanks,
Phil

 

Did you ever get information on how and where to install this?

I need to know too.

 

Don't they normally screw into the Coolant drain plug hole? I'm not sure but when you get the one you ordered, it will probably have directions.

 

As you did, I thought that it would have directions but it did not. The cord is so short that I thought that it must be on the front of the motor or cooling system but did not know where.

I'll check the drain plug hole. Thanks ever so much for responding.

 

http://www.jcwhitney.com/webapp/wcs/...&storeId=10101
that is the block heater i would prefer. it warms the coolant and circulates it so everything warms up. plus it is super easy to install.