So today i decide to install a Fuel pump Kill switch as a theft deterrant, and while examining the wiring I found this...
The SINGLE male connector you see below labeled "D" (single white wire w/brown connector) was "plugged" into the big White DUAL female conector (Dark Blue & Black wires)This connector had no label on it, the thing was just put together, but they were makking no contact since they are TWO DIFFERENT TYPES OF CONNECTORS
I suspect this was done bu the place that installed my alarm (circuit city)
Notice in the backgroud another unplugged White DUAL male connector Labeled "E" (Light blue & black wires)
By looking at the connector alone, it seems to fit into any of the sockets on the fuse panel shown by the arrows on any of the 2 pics below... The problem is, I have NO CLUE where this thing is supposed to go.



On the othe hand the DUAL male NON labeled connector (dark blue & black wires) fits perfectly into the DUAL female connector labeled "E", (light blue and black), Notice the second pic down, however because they are 2 diferent shades of blue I'm hessitant of plugging them together



Help me please!! I cant figure this out, and tthe Hayes manual does not cover this

 

TTT
common guys... someone has to know
Please help,
take a quick look at your car,
the fuse panel is located right above the hood release latch, behind the drivers side kick panel

Look for the wired labeled "D" and "E" like in this pic:

 

Common.. someone has to know what those wires labeled "E" are for..
are they supposed to be connected?

 

I just looked bro and the D wire goes next to that black box on ur last pic. It goes to the left of that and behind the 2 fuses that say 10(red) 20(yellow).

 

Thanks for taking the time to look under the dash man
did you see where the blue and white wires labeled "E" go?

 

Nah I didnt check yet, I will check when I get home. You owe me

 

Owe you BIG time!