Hello everybody. I am planning to disassemble my p/s pump to replace some leaky seals. I was looking in the helms manual and they use a universal holding tool to hold the p/s pump while removing a bolt. The tool is shown in the helms manual, page 17-2, item #11.

Sorry that I can't post a picture of this tool to make it easier. Does anyone have this tool in the Seattle area that I can borrow or rent from them? Can I dissassemble the p/s pump without this tool.

I haven't started this project, but I want to make sure I have everything before I start since the car is my daily driver and I can't afford not to finish the project once I started.

Thanks for any help. If someone knows where I can buy the tool that would be appreciated also if I can't borrow it from somebody.

 

Vice grips could probably be used instead

 

That is what I was thinking to use.

 

:werd:

 

You can probably rent it from AutoZone or something?

 

Unfortunately, there is no autozone in WA state .

 

^^ advanced auto part, o'reilly auto, napa..call around