So I bought the skunk2 front and rear camber kit and am fixin to install them. A question though, where do you set the ball joint at first? I just need it to make it to the alingment shop the same day or mabye the next two. Will it harm my tires badly if I roll on them unalined for a bit? Ive been rolling on f-up'd alingment ever since I put my GC/AGX on so I am familar with bad alingment settings? Will it be drivable? Also, what kind of neg. camber are most of you runnin? Daily driver/commuter here. thanx

 

Your alignment will be very off, install them.. drive the car to an alignment shop asap.

 

thats what i figured. How about the camber specs? anyone have an objectively good spec?

 

This might help: https://www.honda-acura.net/forums/s...ghlight=camber

And this: https://www.honda-acura.net/forums/s...ghlight=camber