anyone else have these, how hard are they to put on

 

i have them they aren't that hard to put on, SEARCH and u will see there is a DIY on how to install them, i think westcoastsyle did the write up and good luck

 

I've installed skunk2 camber kit, i'm sure it going to be the same story for yours.

I used the T-I Diy: http://www.team-integra.net/sections...?ArticleID=783

 

thanks for the thread, looks simple enough, ive replaced the stock one before so i know i little of how to do it, thanks

 

It's pretty straight forward.

 

i got them put on, wasnt to bad, one side took me like over an hour because of the bolts being stuck, but the other side was off and on in about 30 minutes thanks for the help, oh one question, if i took it in to get the camber adjusted, would they of been able to adjust it without the kit, just wondering, now im going in the morning to get a front end alignment