Notices

90 Integra LS problem

Thread Tools
 
Old Feb 16, 2006 | 07:35 PM
  #1  
Will29's Avatar
Will29
Thread Starter
Junior Member
 
Joined: Feb 2006
Posts: 3
Likes: 0
From: Valdosta, GA
Default 90 Integra LS problem

Hi folks...

my car was running well and normally as recently as two days ago, but today when I went to start it...nothing....no radio, no lights, no attenna, and most importantly, no attempt by the engine to start.

The only thing I have done lately is replace the air filter, and I checked all of the battery connections. Just for the heck of it, I got a jump start and it worked fine, but when i tried to restart it, again nothing...

any ideas?
thanks in advance...
Reply
Old Feb 16, 2006 | 07:40 PM
  #2  
Driverman5777's Avatar
Driverman5777
Senior Member
 
Joined: Sep 2005
Posts: 1,769
Likes: 0
From: Hagerstown MD
Default

maybe ur battery is dead, that or ur alternator is gone but either way ur battery is dead.

Last edited by Driverman5777; Feb 16, 2006 at 07:47 PM.
Reply
Old Feb 16, 2006 | 07:43 PM
  #3  
Will29's Avatar
Will29
Thread Starter
Junior Member
 
Joined: Feb 2006
Posts: 3
Likes: 0
From: Valdosta, GA
Default

I put a new battery in, same results....i guess ill have to get a new alternator....thx...
Reply
Old Feb 16, 2006 | 07:46 PM
  #4  
Driverman5777's Avatar
Driverman5777
Senior Member
 
Joined: Sep 2005
Posts: 1,769
Likes: 0
From: Hagerstown MD
Default

yep sorry u lost another battery but if it jumped right up, wait how long did u leave it running after u jumped it? If ur alternator is bad, depending on what u had on it woulden't stay running for long, you could also have a lose circuit somewhere draining power(ie. Headlights, interior lights, loose circuits, etc.) Anyway Welcome to HAN

Last edited by Driverman5777; Feb 16, 2006 at 07:51 PM.
Reply
Old Feb 17, 2006 | 08:32 PM
  #5  
ginomobile/teg's Avatar
ginomobile/teg
Member
 
Joined: Aug 2004
Posts: 96
Likes: 0
Default

the contacts inside of your ingnition switch could be corroded. i had the same problem with my 90 ls and i took it apart and gently sanded down the contact points and it works like a dream now. just a thought...good luck
Reply
Old Feb 20, 2006 | 05:02 PM
  #6  
Will29's Avatar
Will29
Thread Starter
Junior Member
 
Joined: Feb 2006
Posts: 3
Likes: 0
From: Valdosta, GA
Default

I had a blown fuse....I wish Id checked that first...now everything is back to normal...thanks for the suggestions
Reply




All times are GMT -8. The time now is 06:41 AM.