its possible to make an integra 2.0 right? if so, what would i need done and wat parts would i need?

 

A) Get a B20 engine, then swap
B) Get 84.5mm pistons and cylinder sleeves
C) Get a stroker kit.

Done

 

Do a search for Frankenstien motors. I think you should find what you need to know that way.

 

all you need is an 84-85mm bore and you're set. or a big stroke.

 

i'm pretty sure there are a lot of articles out there on this. i've seen tegs bored and stroked out to a 2.2. i think i've even read an article back in the day in honda tuning where they stroked out to a 2 liter. do some searches on here and other sites, maybe even google it and you should get all your information.

 

u can even re-sleeve ur block with dart sleeves bore it out to an 84-85mm 2.0lt

 

big gains doing that?

 

boring out the block will yield more displacement. get it sleeved and bored to 84.5mm and viola, 2.0 GSR.

as far as gains, it depends on what parts you use, what you tune with and who builds it. you get what you pay for in N/A set-ups