The boot has been ripped awhile and when i was installing my camber kit the knuckle w/ the rollers slipped out of the inner joint and was pain to get back in.
I got it to go back in and i drove it apprx 10 miles and was fine then outta nowhere RSide started wobbling hard and couldnt go 30+mph. So what do i need just the RSide drive shaft and boots or is there a fix???

 

I had a similar problem with an inboard joint of mine. Turns out the "remanufactured" driveshaft I replaced my stock axle with had a bad inboard joint. It wasn't as bad as what you are describing but it sounds like the same problem. The easiest way to fix that would be to get a new driveshaft. You can rebuild the joint and re-boot it but it is hardly worth the effort considering axles go for like $60.

 

:werd: to Shmoo. That axle is toast. Replace it.