Shifter Problem
Thread Starter
wtf goes here?
Joined: Dec 2003
Posts: 5,782
Likes: 0
From: Charlotte, NC
Shifter Problem
here lately...something's been messing up in my shifter. I'll be in 2nd gear, at a low speed (roughly 20 mph or so) just driving along, let's say through a parking lot or pulling in my driveway. My shifter will rattle and try to pop out of gear. And when I push in the clutch and pull it down to 2nd again, it grinds a little. Is it my syncromesh? Or something way worse? Any help is greatly appreciated.
Thanks in advance
Thanks in advance
NAM #0001
Joined: Jun 2002
Posts: 4,050
Likes: 0
From: Cornelius, NC
Originally Posted by centerforce99
Throw out bearing might be going bad. That usually gets replaced w/a new clutch so you may be at that point too.
I
Joined: Jan 2001
Posts: 56,525
Likes: 0
From: Westside til I die
It's your tranny.
__________________
2015 Ford Mustang GT Fastback - Ingot Silver - 6M - Performance Package - Gibson Catback, JLT CAI, FR 47lb injectors, BAMA E85 tune, Eibach Sportline, BMR wheel hop kit, UPR oil separator, Steeda shifter bushing/bracket
Team B.O.B.® - Ballaz on a Budget
2015 Ford Mustang GT Fastback - Ingot Silver - 6M - Performance Package - Gibson Catback, JLT CAI, FR 47lb injectors, BAMA E85 tune, Eibach Sportline, BMR wheel hop kit, UPR oil separator, Steeda shifter bushing/bracket
Team B.O.B.® - Ballaz on a Budget
NAM #0001
Joined: Jun 2002
Posts: 4,050
Likes: 0
From: Cornelius, NC
Originally Posted by centerforce99
So me learn me a lesson...why not?
www.ufc.com
Joined: Sep 2004
Posts: 2,920
Likes: 0
From: Irvine CA
Originally Posted by TeHJuSTiN
The TOB could be involved in the second part of his problem (grinding going back into gear) but once the transmission is in gear, the TOB has no effect on it.