I just got my wife a 95 Tegra. Yeah Auto ehhh we got kids. Anyways When Im driving the car I want a bigger pep then the b18b1 I was woundering if I get me a B20 auto and put it in there will I be ok doing the swap or will I need some extra parts? Thanks for the help!

 

well, i don't wanna be annoying, but this post should probably be under the "integra" forum....but anywho...to my knowledge i would assume that u should only need the mounts from the B20 and maybe the throttle cable, the B20 will bolt up to the B18b1 tranny, and that's prolly what u wanna use since the B20 tranny is gonna be AWD and will take alot of custom work to make fit....so what u will probably need the usual engine swap parts...not sure tho

 

a b20 is just a b series meaning that the normal teggy mounts should work fine

 

Ohh s**t my bad Guys. I did'nt even realize that! Mods you can move it to the proper place! Umm Yeah I was thinking of using Both but just realized that the B20 tranny is AWD. Ummm so yeah Im gonna be using the B18 tranny. Now are the B20's OBD1 or 2? I know all of this is stupid cause I can just do a search but I know noone has posted up putting a B20 into an auto.

 

i'm not sure about that one....

 

not all of the CR-V's were all wheel drive so a B20 CR-V 2 wheel drive should work hope this helps

 

the ls ratios are probably better than the crv's though. you could always do a stock b20 vtec for just a daily driver

 

Well Yeah at the moment im only gonna put in the B20 and in the future im gonna slap in the Vtec head.

 

isnt a '95, OBD 1? and a b20 will just bolt right in using the same mounts. a b20 and your b18b is practically the same engine, except for the slightly bigger bore.

(just found that out today)

 

Yes I know that!! The only thing I was asking was about the obd. Thats all!!