What does the 100 come from in 4x100 in the lug setup? I need to get my legend rotors redrilled but, in addition to the factory 5-lug holes, there are also a set of 4 holes that are half drilled. How do I determine if these half drilled through holes are 4x100?

100mm diameter of the bolt-circle. Since there's 4 bolts, you can just measure center-to-center between bolts on opposite sides.

As such.

i just noticed in your sig, "sleeved head". Can you explain that?

i was wondering that as well

Hey, thanks for the image. I always wondered what 4x100 meant. I knew to look for it when killing time looking for wheels....

Future mods

mode list and future mode list > yuo. h:

i want rods too in the future too, since i dont have them in my engine yet.

Sorry for the type, sleeved block. Maybe I should sleeve my head too... jk