Hey, well.. i just got a pair of 17" P1 rims and.. i bought my car slammed and the suspension is a peice of crap, Its very low in the back and not so bad in the front, but I was wondering If i had to raise my car so my 17"s will fit. Im getting 205/40/17 NItto's.
here are the pics.



I have drop zone springs if i have to raise the car, and IF i do, does anyone have good instructions? Thanks.

heres what my teg looks like w/ the rims on a jack


Opinions?

 

if theyre sleave coilovers, you can usually twist them up or down. otherwise, youre stuck with shit.

 

not sure, but im pretty sure they arent after market, they might be cut. i mean I can install dropzone springs, they currently arent in the car. my mistake.

 

damn your front is too high and your rear low, get neuspeed race springs, its looks ugly your car drop like that

 

very nice rims tho, white rims on white car very nice, when you slam it evenly

 

what ever you do do NOTE buy dropzone springs...they are garbage...go with some H&Rs or Neuspeeds or Eibachs or Tein.....NOT dropzone..

 

by the way...the integra unfortunately was made that way. with the front like a 1/2 inch taller than the back. so when you go to buy springs or coilovers, i would recommend getting a 1.75 or 2 inch drop in the front, and a 1.5 inch drop in the back. with 17 inch rims, you will have good enough ground clearance. just be careful on those dips

 

that dosen't look slammed to me? :dunno:

 

if that's slammed, i'm in the ground

 

hahaa....i was about to same the same thing....