Hello again haven't been on here for a while busy talking to shops trying to figure out how i'm going to go about this here is what I'm planning on doin. What u guys think?

I wanna run between 12-15 psi on the street

3 inch greedy cat back
custom made dp and manifold to accept my KKK k3t turbo(since it's a big turbo want to increase my displacement)
Darton Sleeve kit bored out to make it a 2liter with custom made JE pistons 9:1
Crower rods
Turbo Smart E-manage boost controller, Greddy FATT
C&R radiator, B&M oil cooler

 

OK PSI has nothing to do with anything. What are your WHP goals lets start with that. People get hung up on how much PSI they wanna run when they should be thinking how much power they wanna make. Your mods look good except that Greddy E. Just get you a hondata and you won't need that thing. I think its a ok piggie back system but your going to need a Hondata or some kind of stand alnoe, you'll need injectors too. How much poser you talking about maken?

 

it wasn't the E-manage that i had listed it's a TurboSmart E-boost controller my mistake got it confused with greedy anyways I'm planing on making 350 WHP and not sure if i should go Hondata or AEM I think AEM would be better. Also want 550cc injectors and a Bosch fuel pump that Endyn makes to fit in the stock location

 

Your going to need a lot more then what you posted. I would go with 720cc injectors though. Also the Hondata is better then the AEM from what I'm getting from tuners in the local area. Your going to need to do some motor upgrades to run that much power.

 

well said Erik B. WHP is way more impotant then how much PSI you want to run.