I own a 91 integra and had a little accident. A mixture of rain a corner and a blow out. Point is I bent the lower control arm mount(front) on the sub frame. Its probably a quarter inch off to the right. Does anyone know if I can hammer it back or do I need a new subfame? thanks

 

Have you consulted a body shop? I'm not up to par on body repair, but can then bend it back for you?

 

Sounds like you were trying to have some fun..

 

For important stuff like that, I would much rather replace then beat back with a hammer.

 

Thank you for your input everyone. I did contact quite a few body shops only to come across the same answer. DONT TRY TO BEND IT BACK! Guess I have a project this weekend. Thanks again.